Zond geophysical software

[Alex Kaminsky Keymaster]

[gaoxg Participant]

Statistics Corner Function in zondmt2d or zondmt1d,for Distinguish TE or TM mode?

[Alex Kaminsky Keymaster]

I think that I am not completely understand what did You asked about..

[gaoxg Participant]

My english is very pool, and Including professional English.

[alfian Participant]

Excuse me Mr.Kaminsky for disturb your time for read my post…

CS-AMT data which I process contains from the three lines. When I run zondmt2d software, showing the cross section from the two lines on the reverse direction. How do I display them all in zondmt3d? What parameters should I change from these two lines?

I use this software in demo version, may I request to borrow the full version license for one month? every lines which I process contains 200 stations. I use this software for my undergraduate thesis.

I’m Indonesian and I’m sorry if my English is bad.

e-mail:

[Alex Kaminsky Keymaster]

Dear Alfian,
To display all sections in 3D use “3d sections”. This module allow to display interpretation results in 3D view for all lines.

1. Invert all profiles You planning to display.
2. Save all profiles as projects (it will generate *.mod2d files )
3. Load first project.
4. Run “3d section” module
5. Add all other *.mod2d files in table and input coordinates.

Alex

[Author]

Posts